Electrical near Bernal Heights, San Francisco

What we diagnose

Almost anything electrical, from a steady check engine light to the kind of intermittent fault that has already cost two other shops a parts order. On the powertrain side we work through the usual code families in prose so you know what they mean: P0420 and P0430 catalyst-efficiency codes (often a failing front oxygen sensor, sometimes the converter), P0171 and P0174 lean codes from a vacuum leak, dirty MAF, or sticking PCV, P0300 through P0308 misfire codes that point at coils, plugs, or injectors by cylinder, P0011 and P0014 cam-timing codes from a stretched chain or bad VVT solenoid. On the network side, U0100, U0101, and the rest of the U-code family mean a module has stopped talking on CAN; we trace those to the actual broken wire or failed gateway instead of guessing at modules. We also handle ABS and airbag lights, hard starts and no-starts, parasitic battery drain, alternator and starter problems, intermittent stalling, immobilizer and key-fob faults, and aftermarket installs that broke something.

• Check engine light diagnosis (all manufacturers, all code families)
• Parasitic battery drain testing (amp-clamp isolation, fuse-pull method)
• Alternator and charging system testing under load
• Starter, ignition switch, and start-circuit diagnostics
• CAN bus / module communication (U-code) faults
• Wiring repair, connector replacement, soldered splices
• Immobilizer, key fob, and aftermarket alarm / remote-start diagnosis

Tools we use

Bidirectional scan tools like the Autel MaxiSys, Snap-on Solus, and Launch X431 cover most makes for live data, module reflashing, and actuator commands beyond what a parts-store reader can do. A proper labscope and DMM go on the actual wires when the code points at a circuit rather than a part. For sensor work we have the back-probe kits and the wiring diagrams. Dealer-licensed platforms (BMW ISTA, Ford IDS, etc.) we will tell you up front if the job needs one we do not have, because some software-only repairs really do belong at the dealer.

How we diagnose

We do not throw parts at problems. The first hour is diagnostic time. We read codes from every module on the car (not just the engine), test the actual circuit with a meter, and follow the wiring diagram. Once we have proven what is broken, we write you an estimate to fix it. Diagnostic time is billed transparently. You see what we charged for what.

Common SF scenarios we see

A few patterns repeat. Aging Toyota Prius 12V batteries that test fine but kill the car overnight because the auxiliary system never fully shuts down. Toyota and Lexus key-fob immobilizer faults that read as random no-starts on cold mornings. Intermittent CAN-network faults on 2010-2015 Mercedes and BMWs that drop a module under load. Tesla and Bolt low-voltage gremlins that the dealer wants to fix by replacing whole assemblies. Aftermarket alarm installs that bridged the wrong wire and have been silently draining the battery for months. None of those need parts thrown at them; they need somebody who will sit with the car and trace the actual fault.

Why electrical work is different

A new alternator does not fix a bad ground wire. A new battery does not fix a parasitic drain. Most electrical comebacks happen because someone replaced the symptom instead of the cause. We replace the cause.

What it costs

Diagnostic time runs by the hour and we set a cap up front so you are not surprised. Simple problems like a bad ground or a chafed wire we can find in 30 minutes. Complex intermittents on a CAN bus can take longer, but we will check in before we keep going.